Re: [uCsimm] using uCSIMM Port C for IO

From: Uwe Beutin (uwe@hahnnet.de)
Date: Thu Apr 19 2001 - 17:16:43 EDT


On Thu, 19 Apr 2001, Shaun H wrote:

> I assumed that, on boot up, pins 23-30 default to become General Purpose
> I/O Port C. Then the bit0 on Port C should switch on & off?
>
> I know that these pins serve as the LCD Controller also, which is why I
> wondered if there might be a need for some other C command??

Well, did you enable the output? I don't have my docs ready, but I
believe that Port C must be enabled as an output for it to work as such:
I think: 0xFFFFFA13 = 0x00

Check for MC68EZ328 documentation (PDF file), you will need it!

Take care,

        Uwe

This message resent by the ucsimm@uclinux.com list server http://www.uClinux.com/



This archive was generated by hypermail 2b30 : Sun Apr 07 2002 - 00:01:43 EST