Re: [uCsimm] using uCSIMM Port C for IO

From: Shaun H (boo.bar@ntlworld.com)
Date: Thu Apr 19 2001 - 23:41:03 EDT


Hi Evan,

Thanks for your reply :-)

>What do you have attached to port C?
connected to pin 30 on the ucSIMM is a 1K resistor with LED.

I assumed that, on boot up, pins 23-30 default to become General Purpose
I/O Port C. Then the bit0 on Port C should switch on & off?

I know that these pins serve as the LCD Controller also, which is why I
wondered if there might be a need for some other C command??

Thanks,

Shaun

This message resent by the ucsimm@uclinux.com list server http://www.uClinux.com/



This archive was generated by hypermail 2b30 : Sun Apr 07 2002 - 00:01:43 EST