AW: [uCsimm] Very need help!

From: Kirsch Martin (Martin.Kirsch@mhm6.siemens.de)
Date: Tue Apr 17 2001 - 17:25:08 EDT


Hello,

when you reset the module you can transmit the new image.bin over the serial
interface (rx instead of go). After that you can flash it in the rom
(program). After a new
reset it should work. try to use the image that come along with the cdrom.

Martin

-----Ursprüngliche Nachricht-----
Von: gap suen [mailto:gapsuen@hotmail.com]
Gesendet: Dienstag, 17. April 2001 09:28
An: ucsimm@uClinux.com
Betreff: [uCsimm] Very need help!

Dear all,
After i have changed the config. file, then I upload the image.bin file
again.
However, I cannot boot it again.
So, what can I do to initialise the uCsimm board in this case?
thx..
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.

This message resent by the ucsimm@uclinux.com list server
http://www.uClinux.com/

Virus checked by Siemens AG I&S IS GFA Mannheim
This message resent by the ucsimm@uclinux.com list server http://www.uClinux.com/



This archive was generated by hypermail 2b30 : Sun Apr 07 2002 - 00:01:43 EST