Re: [[uCsimm] question on running ucsimm]

From: Richard Sevenich (rsevenic@netscape.net)
Date: Fri Nov 24 2000 - 20:15:55 EST


Presumably you have your uCsimm powered appropriately via a power adapter or
whatever? When you configure minicom, have you chosen the device as /dev/ttyS0
or /dev/ttyS1? If you haven't tried both, you might.

Regards,
Richard

> WeiOwen@aol.com wrote:
> Hi,
> I use minicom(configured as required) and follow the following
> instruction to power up my simm, but I didn't see any rersponse in the
> terminal. I don't know what is wrong. Does anybody know what could be my
> problem?
> Thanks
>
> Weiowen
>
> " ensure simm is attached to your workstation via serial port, and start a
> terminal emulator (such as minicom). Make sure that the serial port you are

> using is configured to 9600bps 8N1 with NO hardware or software flow
control,
> and set the modem init and reset strings to empty. When you power up the
> uCsimm, you should see 'uCbootstrap v1.x....etc,' followed by a prompt.
> This message resent by the ucsimm@uclinux.com list server
http://www.uClinux.com/

____________________________________________________________________
Get your own FREE, personal Netscape WebMail account today at http://home.netscape.com/webmail
This message resent by the ucsimm@uclinux.com list server http://www.uClinux.com/



This archive was generated by hypermail 2b30 : Sun Apr 07 2002 - 00:01:39 EST