route command gives:
destination gateway genmask flags metric ref use iface
192.168.1.11 * 255.255.255.255 UH 0 0 0 eth0
192.168.1.0 * 255.255.255.0 U 0 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
No gateway to ISP, just have the two machines interconnected.
The uCsimm has IP 192.168.1.200 at the moment.
I've also tried
laptop IP = 192.168.1.1
since the uCsimm would see that as its gateway.
Phil Wilshire <firstname.lastname@example.org> wrote:
> lets see the output from the
> mine is...
> [philw@bierk philw]$ /sbin/route
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use
> 192.168.2.231 * 255.255.255.255 UH 0 0 0
> 192.168.2.0 * 255.255.255.0 U 0 0 0
> 127.0.0.0 * 255.0.0.0 U 0 0 0
> default 192.168.2.100 0.0.0.0 UG 0 0 0
> where the default line 192.168.2.100 is a Moreton Bay 2500 acting as an
> ISP gateway.
> you may need to
> /sbin/route add -net 192.168.2.0 netmask 255.255.255.0 dev eth0
> Phil Wilshire
> > Another newbie question for my new uCsimm setup.
> > I have serial communication established between my laptop and the uCsimm
> > which is on the uCgardener. I now want to establish the ethernet
> > Both the uCsimm and laptop recognize their respective ethernets, each has
> > different IP address on the same subnet etc., each can ping itself by the
> > proper IP - but neither can ping the other. I believe I have the
> > machines set up properly, but perhaps there
> > is something I've missed. Any hints?
> > The laptop's ethernet pcmcia card is new, so it could have a RJ45
> > problem I suppose. The two machines are connected by a crossover cable,
> > also tried with regular cables and my hub.
> > I would appreciate hints/advice.
> > TIA,
> > Sev
> This message resent by the email@example.com list server
Get your own FREE, personal Netscape WebMail account today at http://webmail.netscape.com.
This message resent by the firstname.lastname@example.org list server http://www.uClinux.com/
This archive was generated by hypermail 2b30 : Sun Apr 07 2002 - 00:01:37 EST