Re: [uCsimm] loading uc

From: Tom Walsh (tom@cyberiansoftware.com)
Date: Wed May 03 2000 - 00:37:55 EDT


Edward Benavides wrote:

> The processor used for my project is the dragonballEZ.
> I have my processor up in bootstrap mode and I get the @.
> How do I load the uclinux and what crosscompiler do I use to compile my
> c code for the m68k?
>

If you are not using ucsimm, then look at:
'http://www.openhardware.net/Users/TomW/'. The rpms are there for downloading + a
doc outlining how to set up a development center. If you have engineered your own
PCB design then you should not have any problems understanding the setup and be able
to modify it to your needs.

Regards,

TomW

>
> -Thanks
> tony
>
> This message resent by the ucsimm@uclinux.com list server http://www.uClinux.com/

--
Tom Walsh - WN3L - Embedded Systems Consultant
'www.openhardware.net', 'www.cyberiansoftware.com'
"Windows? No thanks, I have work to do..."

This message resent by the ucsimm@uclinux.com list server http://www.uClinux.com/



This archive was generated by hypermail 2b30 : Sun Apr 07 2002 - 00:01:35 EST