From: Robert Schwebel (robert@schwebel.de)
Date: Mon Sep 09 2002 - 02:00:42 EDT
On Mon, Sep 09, 2002 at 09:31:54AM +0800, Aavan wrote:
> I'm working on StrongARM SA1110 board with kernel 2.4.2-rmk-np3, I
> changed the cs89x0's interrupt pin to GPIO1 on my new board. So I need
> to modify the cs890x's device driver to make the net device work
> normally. But I don't know where the cs89x0's drivers register the
> Interrupt pin.
Did you try it with "ether=[irq,io]" on the kernel command line? For a
(non-uclinux) AMD Elan based system with cs8900 I use
ether=0,0x301,eth0
^
|
This means "don't autoprobe, use 0x301 as base address
Robert
--
Dipl.-Ing. Robert Schwebel | http://www.pengutronix.de
Pengutronix - Linux Solutions for Science and Industry
Braunschweiger Str. 79, 31134 Hildesheim, Germany
Phone: +49-5121-28619-0 | Fax: +49-5121-28619-4
This message resent by the uclinux-dev@uclinux.org list server http://www.uClinux.org/
This archive was generated by hypermail 2.1.4 : Thu Sep 19 2002 - 13:21:50 EDT